After connecting the GF-TPM to your computer for the first time, it is necessary to calibrate the three control levers so that they have effect throughout their entire range of motion. After this process has been completed, you will not have to repeat the calibration steps unless you: (a) wish to change the lever response… read more
Blog
Posts in Category: SUPPORT
NOTE If you own other GoFlight hardware and have already installed the most current version of software on your system, you do not need to install the software again. Simply skip the software installation steps in the instructions below. 1. Get on line and go to www.goflightinc.com. 2. On the GoFlight home page click Support…. read more
Example: To connect the individual hardware components to the DIO Board, use the cable assemblies that come with your DIO purchase. On both the components and the board itself, there are 3-pin connectors which simply plug into the connectors on the ends of the cable assemblies Each component takes a different amount of cables depending… read more
Mounting Options: Option 1 – Screw Mounted (not pictured). The GF-DIO board comes with standoff screws giving you the option to screw mount your GF-DIO board where you place within your home built cockpit. Option 2 – Double Sided Tape (pictured below) Another simple option is to use a few strips of double mounted sticky… read more
1. Remove the four corner screws from the front panel. 2. Remove the electronics from the back case. 3. Insert the two #4 – ¼” screws into the end you wish to mount you GF-EFIS to the GF-MCP Pro. 4. Mount the case to the MCP Pro case as shown below and tighten the screws. 5. Replace… read more
Freestanding Mounting Option Desktop: Included are two triangular brackets. Attach these brackets as shown to both ends: AC Rack Mounting Option Remove the GF-MCP Pro’s electronic from the case buy removing the four front panel screws. Attach the case to the AC Rack with the enclosed screw as shown: Place the electronic back into the… read more
Main Control Lever Calibration After connecting the GF-TQ6 to your computer for the first time, it is necessary to calibrate the six main control levers so that they have effect throughout their entire range of motion. After this process has been completed, you will not have to repeat the calibration steps unless you: (a) wish… read more
Installing GF-Config Software NOTE: If you own other GoFlight hardware and have already installed the most current version of software on your system, you do not need to install the software again. Simply skip the software installation steps in the instructions below. 1. Using a web browser go to www.goflightinc.com. 2. On the GoFlight home… read more
a MagLabel sheet as illustrated in the following depiction: GoFlight’s MagLabels are used to label the displays and buttons on the GF-166 for easy reference during flight. Using a pair of scissors, carefully cut out the labels that you wish to place on the panel to correspond with functions you have assigned using GF-Config. Due… read more
Installing GF-Config Software 1. Using a web browser go to www.goflightinc.com. 2. On the GoFlight home page click Support. 3. Click on “GF Config x.xx” to download the latest module drivers and configuration software. 4. Click “Run” or “Save” and then follow the instructions to install the software. If the software installer detects that GoFlight… read more