Important Notice During this COVID-19 Pandemic

Hello to our amazing customers and fans. Do to the out break of the corona virus and a order form state government, executive order No.20-12, In compliance with this order. GoFlight has temporally closed its doors. We will continue to accept orders, but we will not ship until the executive order has been lifted.

PLEASE NOTE: While we are closed. A cancellation fee of 10% will be incur if an existing order is cancelled.

Call Today:  503-901-7573
You're a Go with GoFlight
Contact Us

Connecting the Hardware to the GF-DIO Board

The GF-DIO Board comes with 88 positions for components to be added. Each position is a made up of a 3-pin connection. Once the hardware components are plugged into the wire assembly, plug the other end of the wire assembly into one of the positions on the DIO board, taking note of the number position for later configuration. 

GF-DIO connection form board to external switch

Take note the 3-pin connectors have two positions each and a ground wire in the middle. The order works like this, first pin is the first position, second pin is the ground wire and the third pin is the second position. Then on the next wire, the first pin repeats the second position, the second pin remains as the ground and the third pin is the third position. The pattern repeats throughout the DIO board.

Comments are closed.

Phone:
503-901-7573
Tech Support:
Tech Support: 503-688-7921
Address:
163 SW Freeman Avenue
Suite B
Hillsboro, Oregon 97123
Designed & Created by Pegasus Online