Important Notice During this COVID-19 Pandemic

Hello to our amazing customers and fans. Do to the out break of the corona virus and a order form state government, executive order No.20-12, In compliance with this order. GoFlight has temporally closed its doors. We will continue to accept orders, but we will not ship until the executive order has been lifted.

PLEASE NOTE: While we are closed. A cancellation fee of 10% will be incur if an existing order is cancelled.

Call Today:  503-901-7573
You're a Go with GoFlight
Contact Us

Installing and Configuring the GF-MESM Module

Installing the GF-Config Software

1. Get on line and go to

2. On the home page click Support tab then Latest Software Update

3. Click on Latest Software Up-date to download our latest module drivers and configuration software.

4. Click “Run” or “Save” and follow the instruction to load your software If the software installer detects that GoFlight software is already installed on your system, it will prompt you to overwrite. Click the Yes button to overwrite the existing version of GoFlight software. This is useful if you wish to keep the configuration settings for other GoFlight modules installed on your system. However, you should first make sure that the software you are overwriting is an older version and not a newer one.

Installing the GF-MESM Module into the GoFlight Flight Deck Console

If you are planning to install the GF-MESM module into a GoFlight rack enclosure, install the module in any desired location in the enclosure. Fasten the module in place using the two thumbscrews that are included in the GF-MESM packaging being careful not to over-tighten them.

Installing a GF-P8 module in a console

Configuring the GF-MESM Module

After you install the GoFlight software and connected the GF-MESM for the first time, run the GF-Config program, which is located in your Programs menu under “GoFlight”. Verify that GF-Config displays a picture example representing the GF-MESM unit on the left-hand side of the program window. Click on the GF-MESM picture to show the configuration options in the right side of the program window.

Comments are closed.

Tech Support:
Tech Support: 503-688-7921
163 SW Freeman Avenue
Suite B
Hillsboro, Oregon 97123
Designed & Created by Pegasus Online