Important Notice During this COVID-19 Pandemic

Hello to our amazing customers and fans. Do to the out break of the corona virus and a order form state government, executive order No.20-12, In compliance with this order. GoFlight has temporally closed its doors. We will continue to accept orders, but we will not ship until the executive order has been lifted.

PLEASE NOTE: While we are closed. A cancellation fee of 10% will be incur if an existing order is cancelled.

Call Today:  503-901-7573
You're a Go with GoFlight
Contact Us

Installing and Removing Detent Plates on a GF-TQ6

Your GF-TQ6 ships from the factory with two detent plates than can be optionally mounted to the top panel of the GF-TQ6 enclosure. These detent plates provide stopping points for the control levers in the A and F positions. One of the plates is designed to provide detents for spoiler control, with stops in the Fully Retracted, Armed, and Operating Range positions. The other plate provides detents for up to 6 “notches” of flaps. Using GF-Config software, you can designate various control actions to occur when the control levers are placed each of the detent position, referred to in the software as “zones.” For more information about zone assignments, please refer to the GF-Config on-line help.

Comments are closed.

Phone:
503-901-7573
Tech Support:
Tech Support: 503-688-7921
Address:
163 SW Freeman Avenue
Suite B
Hillsboro, Oregon 97123
Designed & Created by Pegasus Online