|Elevator Trim||The wheel on the left side of the GF-LGT II panel is used to adjust your Flight Sim aircraft’s elevator trim. Move the wheel upwards to trim the nose of the aircraft down. Move the wheel downwards to trim the nose of the aircraft up.|
|Aileron Trim||The wheel on the top of the GF-LGT II panel is used to adjust your Flight Sim aircraft’s aileron trim. Move the wheel from left to right to adjust the aileron trim.|
|Rudder Trim||The knob on the bottom of the GF-LGT II panel is used to adjust your Flight Sim aircraft’s rudder trim. Rotate the knob clockwise or counter clockwise to adjust the rudder trim.|
|Flaps||The flaps switch is located on the right side of the GF-LGT II panel. The switch is spring-loaded so that it rests in a center position. This control is ideal for controlling flaps on a variety of aircraft that may have differing numbers of “notches” of flaps. To extend (lower) your Flight Sim aircraft’s flaps 1 notch, push the flaps switch down once, and release it. To retract (raise) your aircraft’s flaps 1 notch, push the flaps switch up once, and release it. Pushing the switch more than once will adjust the flaps through additional notches as necessary.|
|Landing Gear||The lever in the center of the GF-LGT II panel is used to control the position of your Flight Sim aircraft’s landing gear. The lever has three positions – UP, NEUTRAL, and DOWN. From the NEUTRAL position, gently pull the gear lever outward and then upward to retract the landing gear. Likewise, gently pull the gear lever outward and then downward to extend the landing gear. The three LEDs on the panel show the current status of the landing gear, as follows:|
Red – Landing gear is transitioning between UP and DOWN positions.
Green – Landing gear is down and locked.
Off – Landing gear is up and stowed.
|Configurable 3-position Toggle Switch||This switch can be programmed for various functions as appropriate to your Flight Sim environment. One example could be the of the Fuel Tank Selection function. Please note that a set of Magnetic Labels have been included for this purpose.|