Call Today:  503-895-0242
You're a Go with GoFlight
Contact Us

Using the audio filter function of the GF-ATC module

Plug your headset into the “MIC” and “HEADSET” jacks on the front panel. (Your speakers may be plugged into the rear of the card or into the front panel.)

There are two controls on the front panel of your GF-ATC:

  • VOL knob is to set the volume you desire of the overall sound to your headset.
  • SQL knob stands for squelch. While in your Flight Simulator and with Air Traffic Control (ATC) talking, adjust the SQL control full counter clockwise. The sound of air traffic control should no longer be audible in your headset. Slowly turn the SQL control clockwise until you can hear air traffic control (ATC) again. When air traffic control (ATC) stops speaking, the sound in your head set should also stop.

Adjusting audio sliders

Setting up your sound in FSX. In order to use the SQ feature on your ATC you need to setup the Audio Sliders in FSX. To do this open FSX, click on the Settings then Sound. Now you will see four sliders. The Engines slider needs to be adjusted to the left so the SQ will work if the Engine sound is to high the SQ will not cutoff the sound. All other sliders need to be adjusted to a comfortable level.

Note: When plugging your headset in the ATC headset jack you are getting processed sound, it is going to sound gabbled like aircraft commutation. If you want clean sound that is not processed use the Speaker jack on the front of the ATC panel.

Comments are closed.

Phone:
503-895-0242
Tech Support:
Tech Support: 503-688-7921
Address:
163 SW Freeman Avenue
Suite B
Hillsboro, Oregon 97123
Designed & Created by Pegasus Online